YarnPath

Home › Questions › Amigurumi problems

Crochet · Fixing mistakes

Amigurumi problems: stuffing showing and wobbly heads

Stuffing shows through amigurumi when the stitches are too loose for the yarn: use a hook well below the one on the yarn label, often 3.5 to 4 mm for worsted, and work decreases as invisible decreases through the front loops. A head wobbles when the neck is narrow or soft: stuff the neck firmly and sew the head on all the way round the opening.

Causes and fixes

  1. Stuffing shows between the stitches.

    Check: You can see white fibrefill through the fabric, especially where it stretches over a curve.

    Fix: Go down a hook size or two until the fabric is firm. Some makers also wrap the yarn under the hook instead of over (yarn under), which makes smaller, X-shaped single crochets.

  2. Holes or bumps at decreases.

    Check: Each decrease leaves a small gap or a ridge, in a line up the piece.

    Fix: Use the invisible decrease. Insert the hook into the front loop of the next stitch and the front loop of the one after, yarn over, pull through both front loops, yarn over and pull through the two loops on the hook.

  3. A wobbly head.

    Check: The head flops forward or to the side once it is sewn on.

    Fix: Stuff the neck and the bottom of the head firmly, right up to the opening, pin the head in place, and sew all the way round the opening, not just at a few points.

  4. Lumpy stuffing.

    Check: The surface has bumps and dents.

    Fix: Pull the fibrefill apart into small, fluffy pieces and add it a little at a time, pushing it into the far end first and shaping as you go.

  5. Lost track of the round.

    Check: Pieces worked in a continuous spiral end up with too many or too few rounds.

    Fix: Put a stitch marker in the first stitch of each round and move it up as you reach it. Do not join with a slip stitch unless the pattern says so; most amigurumi is worked in a spiral.

Common questions

When should I put in safety eyes?

Before you close the piece, while you can still reach inside to fix the washer. Try the position with pins or stitch markers first: once the washer is pushed on, it is very hard to remove. For toys for children under 3, the age that toy small-parts rules use, embroider the eyes instead.

Should I work in a spiral or in joined rounds?

A spiral has no line of joins, which is why most amigurumi uses it, though colour changes leave a small step. Joined rounds leave a visible line of joins but keep colour changes neat. Follow the pattern.

How firmly should I stuff?

Firmly enough that the piece holds its shape and springs back when squeezed, but not so much that the stuffing stretches the stitches open and shows through.

Still not sure what is going on? The YarnPath app will look at a photo of your work and tell you which of these it is. About the app →

Updated 8 November 2026.