Questions
When something goes wrong
Each question gets a short answer first, then the causes, how to check for each, and the fix.
Fixing mistakes
- Why is my crochet getting wider?Crochet that gets wider row by row is gaining stitches, almost always at the edges: working into the turning chain, working twice into the first stitch,...
- Why is my crochet getting narrower?Crochet gets narrower when the last stitch of each row is skipped. That stitch is small and hides behind the turning chain of the row below,...
- Why is my crochet curling?Flat crochet curls when one part is tighter than the rest, most often a foundation chain worked tighter than the stitches above it. Make the chain...
- Why is my knitting curling?Stockinette stitch curls because knit stitches are slightly narrower than purl stitches: the sides roll towards the purl side and the top and bottom towards the...
- Why are there holes in my knitting?An unplanned hole in knitting is usually an accidental yarn over (the working yarn crossed over the needle between stitches, adding a stitch and a hole),...
- How to fix a dropped stitch in knittingPut a locking stitch marker or a safety pin through the loose stitch so it cannot run further. Knit to where it belongs, then insert a...
- Why are my knitting edges loose and messy?Knitting edges look loose because the first and last stitch of each row are worked with less tension: the yarn travels around the edge and nothing...
- Crochet too tight or too loose?Tight crochet usually comes from pulling the yarn taut and forming loops on the narrow throat of the hook; loose crochet from letting the yarn run...
- Why is my bind-off too tight?A bind-off is too tight when the yarn is pulled snug between stitches, so the edge cannot stretch as far as the knitting below it. Bind...
- Knitting in the round problems and fixesFour things go wrong most when knitting in the round: ladders (a column of loose stitches where two needles meet), a twisted join (the cast-on twisted...
- Why do I have extra stitches in my knitting?Extra stitches usually come from an accidental yarn over, when the yarn passes over the needle as you move it between front and back, or from...
- Amigurumi problems: stuffing showing and wobbly headsStuffing shows through amigurumi when the stitches are too loose for the yarn: use a hook well below the one on the yarn label, often 3.5...
- Granny square problems: twisting, gaps and wavy edgesA granny square twists or slants when every round is worked in the same direction, because each round leans a little the same way. Turning the...
Planning a project
- How much yarn do I need for a blanket?A knitted throw (50 × 60 in) takes about 1,730 to 2,350 yards of worsted yarn, 1,150 to 1,550 of bulky or 700 to 1,000 of...
- How many stitches to cast on for a hat?Cast on enough stitches for about 90% of the head's circumference, so the hat stretches to fit. For an average adult head of 21.5 in (55...
Reading patterns
- What does "work even" mean in knitting and crochet?"Work even" means carry on in the stitch pattern you are already working, without increasing or decreasing, so the stitch count stays the same. "Work even...
- What does "at the same time" mean in a knitting pattern?"At the same time" means two instructions run together: keep doing the first one (for example, decreasing at the side every 4th row) while you also...
- M1L vs M1R, and how to work eachM1L (make 1 left) and M1R (make 1 right) both add one stitch by picking up the horizontal strand between two stitches, and they lean in...