Home › Questions › Knitting in the round
Knitting in the round problems and fixes
Four things go wrong most when knitting in the round: ladders (a column of loose stitches where two needles meet), a twisted join (the cast-on twisted around the needle), garter stitch instead of stockinette (from turning the work after each round), and knitting inside out (the purl side facing out). Check the cast-on lies flat before you join, and never turn the work.
Causes and fixes
Ladders.
Check: A vertical line of loose, stretched stitches where two double-pointed needles meet, or where the cable of a magic loop starts.
Fix: Knit the first stitch after each change of needle normally, then pull the yarn firm as you work the second. If the line persists, move the gap by shifting a few stitches from one needle to the next every few rounds.
A twisted join.
Check: The cast-on edge spirals around the needle instead of running along its inside edge.
Fix: Before you join, lay the cast-on edge facing the centre all the way round, with no twist. Check again after the first round. A twist found then can be moved into the cast-on edge by passing one needle tip through the middle of the circle. After more rounds it is set; rip back and join again.
Garter stitch instead of stockinette.
Check: The fabric has ridges on both sides, as if every round were purled on the outside.
Fix: You turned the work after each round and knitted back the other way. In the round, keep going in the same direction, with the outside of the tube facing you, and knit every round.
Knitting inside out.
Check: The purl bumps face outwards while you work, and the smooth knit side is inside the tube.
Fix: The work flipped so you are knitting on the far side of the circle. This is harmless, in plain knitting and in colourwork. The stitches are the same and the floats are still on the wrong side. Many knitters work colourwork inside out on purpose to keep the floats loose. Turn the tube right side out when you are done.
Common questions
Which is best for small rounds, DPNs or magic loop?
Both work. DPNs have more needle joins, so more places for ladders; magic loop has two. Use whichever you find easier to hold, and snug the first stitches at each join either way.
How do I join in the round without a gap?
Knit the first stitch with the working yarn pulled firmly, or cast on one extra stitch, slip it onto the left needle and knit it together with the first stitch. Tidy any small gap with the cast-on tail when you weave it in.
Still not sure what is going on? The YarnPath app will look at a photo of your work and tell you which of these it is. About the app →
Updated 8 November 2026.